Proxmox setup help

Leshy

Disciple
Hi I have the following setup

Ryzen 5 5600G

Gigabyte B550Mds3h

64 GB corsair vengeance ram

tp link tx201 2.5 gig lan card and on board GBE Nic from Realtek

I would also like to know how to passthrough the onboard SATA ports on to the true NAS VM

also how can I run the PF sense using the 2 NICs

I would like to run proxmox and pf sense and docker containers need your help
 
5600g might be a lot for running pfsense, do you plan on adding more VM? My setup as shown below, passing the nics as raw pci devices. There are many tutorials on this.
 

Attachments

Yes I plan to run a lot more VMs like a true NAS setup wireguard and portioner for docker containers
 
Last edited:
I am planning to use an M.2 SSD for my boot drive the board has 4 SATA ports can from what I gathered its possible to passthrough all 4 sata ports
 
If you're not connecting a boot drive to it, then passing the onboard SATA controller should work out.
 
Refer these for more insights..


 

Had to pay 1000 rs customs. So around 2.5k...
Delivery time is also the same as amazon takes. Looks like the amazon seller is a dropshipper
Also will need one of this: CableCreation Mini SAS 36Pin (SFF-8087) Male to 4 SATA 7Pin Female Cable, Mini SAS Host/Controller to 4 SATA Target/Backplane, 1.0M https://amzn.in/d/1xrjmts
 

Had to pay 1000 rs customs. So around 2.5k...
Delivery time is also the same as amazon takes. Looks like the amazon seller is a dropshipper
Also will need one of this: CableCreation Mini SAS 36Pin (SFF-8087) Male to 4 SATA 7Pin Female Cable, Mini SAS Host/Controller to 4 SATA Target/Backplane, 1.0M https://amzn.in/d/1xrjmts
got it thanks placing the order