ajish65
Patron
I have a Kreo Chimera wireless mouse and would like to replace the current skates with PTFE skates. However, I could not find any readymade feet, since I guess they're a smaller brand. But I did find this PTFE sheet on Amazon.
So anyone have any personal experience with cutting mouse skates out? Especially the small circle around the sensor? The Amazon page says I need to sand down the cut edges; is that necessary? Asking because I'll have to find sandpaper somehow.
Also, any other tips are welcome. Sources for precut skates for this particular mouse are most welcome.
Thanks for reading.
So anyone have any personal experience with cutting mouse skates out? Especially the small circle around the sensor? The Amazon page says I need to sand down the cut edges; is that necessary? Asking because I'll have to find sandpaper somehow.
Also, any other tips are welcome. Sources for precut skates for this particular mouse are most welcome.
Thanks for reading.