To build my assembly I need to insert two bearings at either end of a roller, but when I pull the bearing from toolbox it comes out as a generic size but I cannot edit it as the sizes are greyed out, there are however codes aligned to bearing sizes but seem indiscriminate, I spent over an hour trying to find the size I required but recon there must be an easier way than this.
Can you help please?
I have never had much success with the SW toolbox so rarely look at it anymore. I know this doesn't answer your question, but I have found my solution downloading 3D bearings from places like McMaster-Carr and SKF. This is much easier in my opinion.